3C574_CS

3c574_cs ? 3Com 3c574 Etherlink XL 10/100 PC Card device driver

insmod 3c574_cs.o [pc_debug=n] [if_port=n] [irq_list=i,j,...] [full_duplex=n] [max_interrupt_work=n]

3c574_cs is the low-level Card Services driver for the 3Com 3c574 EtherLink XL PCMCIA ethernet adapter. When this driver is attached to a card, it allocates the next available ethernet device (eth0..eth#). This device name will be reported in the kernel log file, and passed on to cardmgr(8).

The driver uses the N-Way autonegotiating transceiver to negotiate the speed and duplex of the network link. If the link partner does not support negotiation, only the link speed is detected.

pc_debug=n

Selects the PCMCIA debugging level. This parameter is only available if the module is compiled with debugging enabled. A non-zero value enables debugging.

if_port=n

Selects the transceiver type. Only 0, 1, and 4 are acceptable values, other values return an error. This actual value specificed is ignored -- the autonegotiating transceiver selects the media speed and duplex used.

irq_list=i,j,...

This option limits the set of interrupts that may be allocated by this driver. The default is all normally-usable IRQs.

full_duplex=n

This flag determines if only full-duplex modes are advertised. It defaults to 0 (false).

max_interrupt_work=work-limit

This option selects the maximum amount of work handled during each interrupt. Each received packet counts as one unit of work, as does updating statistics counters and handling errors. The default is 32.

eth#: interrupt(s) dropped!

Indicates that the driver did not receive an interrupt notification for some reason. The driver will poll the card (with a significant performance penalty) if the problem persists. The most likely cause is an interrupt conflict and/or host bridge configuration problem.

Driver core: Donald Becker ? becker@scyld.com

PC Card interface: David Hinds ? dahinds@users.sourceforge.net

cardmgr(8), pcmcia(5), ifport(8).