SMC91C92_CS

smc91c92_cs ? SMC 91cxx device driver

insmod smc91c92_cs.o [pc_debug=n] [if_port=n] [irq_list=i,j,...]

Smc91c92_cs is the low-level Card Services driver for SMC 91c92, 91c94, 91c96, and 91c100 based PC Card ethernet adapters. When this driver is attached to a card, it allocates the next available ethernet device (eth0..eth#). This device name will be reported in the kernel log file, and passed on to cardmgr(8).

With the default transceiver setting, the driver will attempt to continuously autodetect the transceiver type (10base2 or 10baseT). There should normally only be a one or two second lag before the correct transceiver is selected. On particularly noisy or busy networks, it is possible for the detection logic to incorrectly toggle the transceiver type. If this becomes a problem, it may be necessary to explicitly select the interface type when the module is loaded or with the ifport command.

pc_debug=n

Selects the PCMCIA debugging level. This parameter is only available if the module is compiled with debugging enabled. A non-zero value enables debugging.

if_port=n

Selects the transceiver type. 0 is autodetect (10baseT or 10base2), 1 is 10baseT (twisted pair), and 2 is 10base2 (BNC, or thin net). The default is 0 (autodetect).

irq_list=i,j,...

Specifies the set of interrupts that may be allocated by this driver.

eth#: interrupt(s) dropped!

Indicates that the driver did not receive an interrupt notification for some reason. The driver will poll the card (with a significant performance penalty) if the problem persists. The most likely cause is an interrupt conflict and/or host bridge configuration problem.

eth#: interrupt(s) dropped!

Indicates that the driver did not receive an interrupt notification for some reason. The driver will poll the card (with a significant performance penalty) if the problem persists. The most likely cause is an interrupt conflict and/or host bridge configuration problem.

David Hinds ? dahinds@users.sourceforge.net

cardmgr(8), pcmcia(5), ifport(8).